Ovaj oglas je neaktivan.
Pronjuškaj slične oglase.
Osnovne informacije
- Lokacija
- Grad Zagreb, Novi Zagreb - Zapad, Siget
- Stanje
- rabljeno
Opis oglasa
SCS PTC-II (Potpupo uredan i ispravan)
FEATURES PTC-II
Three simultaneously available communication ports: HF and up to two VHF/UHF Packet ports
Separate transceiver control port for remote operation of Icom, Kenwood, Yaesu, R&S and SGC equipment.
32-bit system with Motorola RISC processor 68360 as CPU, clocked at 25 MHz.
16-bit Motorola DSP 56156 clocked at up to 60 MHz (computing power: 30 MIPS)
Expandable to 2 MB of static RAM.
Firmware stored in flash memory. Easy update via serial RS232 link to the PC. The update is free of charge and available from many Packet-Radio mailboxes and from Internet sites
Modem tones (mark-space) and shift programmable in 1 Hz steps within all modes.
Audio output-levels for all PSK- and FSK-modes programmable seperately.
Equipped for FAX (AM, FM, Meteosat), SSTV, CW operation with receiption and transmission and full compatibility to nearly all modern PC programs.
Build-in mailbox with comprehensive features of nearly 2MB maximum size (dependent on RAM installed) with common and simultaneous access from allmodes (PACTOR-I & II, AMTOR, PACKET).
Battery backup for the clock and C-MOS RAM. No mail-loss when switched off.
Mail display at the frontpanel shows the operator at once if there is a new mail for him.
Excellent tuning display with 15 2-color-LEDs with center-function. The antique X-Y-tube display is not required any more.
All significant link and controller stati are displayed at the frontpanel with 2-color LEDs and on the terminal-screen.
10-character dot-matrix-display for mode and other parametes as the callsign of a connecting station and much more.
Channel-busy detection displayed on the PTC-display as well as on the terminal-screen.
DSP-filter option implemented: The PTC-II is fully usable as DSP-filter for all modes as SSB, CW and others as (denoiser) with freely programmable sets of parameters.
Features: Auto-peak, auto-notch, passband-filter, inversion, delay-line, function-generator and more.
Comprehensive filtering of all in- and outputs for excellent electromagnetic compatibility.
HF VHF/UHF gateway and crossband digipeating with comprehensive and automated link establishment features from remote. PACTOR goes PACKET.
Hostmode, extended hostmode, CRC-hostmode. Fullcompatible to nearly all modern PC programs. Fully
integratable in FBB/Winlink networking and mailingsystems
Datacontrôleur HF et VHF
Equipé des cartes modem 1200/2400 b et modem DSP 9600b packet
En parfait état de marche, programme sous Windows et avec documentation complète et schémas
Manual link:
http://www.sa6tlu.se/pmwiki/uploads/Utrustning/scs_ptc_II_manual_v4.pdf
FEATURES PTC-II
Three simultaneously available communication ports: HF and up to two VHF/UHF Packet ports
Separate transceiver control port for remote operation of Icom, Kenwood, Yaesu, R&S and SGC equipment.
32-bit system with Motorola RISC processor 68360 as CPU, clocked at 25 MHz.
16-bit Motorola DSP 56156 clocked at up to 60 MHz (computing power: 30 MIPS)
Expandable to 2 MB of static RAM.
Firmware stored in flash memory. Easy update via serial RS232 link to the PC. The update is free of charge and available from many Packet-Radio mailboxes and from Internet sites
Modem tones (mark-space) and shift programmable in 1 Hz steps within all modes.
Audio output-levels for all PSK- and FSK-modes programmable seperately.
Equipped for FAX (AM, FM, Meteosat), SSTV, CW operation with receiption and transmission and full compatibility to nearly all modern PC programs.
Build-in mailbox with comprehensive features of nearly 2MB maximum size (dependent on RAM installed) with common and simultaneous access from allmodes (PACTOR-I & II, AMTOR, PACKET).
Battery backup for the clock and C-MOS RAM. No mail-loss when switched off.
Mail display at the frontpanel shows the operator at once if there is a new mail for him.
Excellent tuning display with 15 2-color-LEDs with center-function. The antique X-Y-tube display is not required any more.
All significant link and controller stati are displayed at the frontpanel with 2-color LEDs and on the terminal-screen.
10-character dot-matrix-display for mode and other parametes as the callsign of a connecting station and much more.
Channel-busy detection displayed on the PTC-display as well as on the terminal-screen.
DSP-filter option implemented: The PTC-II is fully usable as DSP-filter for all modes as SSB, CW and others as (denoiser) with freely programmable sets of parameters.
Features: Auto-peak, auto-notch, passband-filter, inversion, delay-line, function-generator and more.
Comprehensive filtering of all in- and outputs for excellent electromagnetic compatibility.
HF VHF/UHF gateway and crossband digipeating with comprehensive and automated link establishment features from remote. PACTOR goes PACKET.
Hostmode, extended hostmode, CRC-hostmode. Fullcompatible to nearly all modern PC programs. Fully
integratable in FBB/Winlink networking and mailingsystems
Datacontrôleur HF et VHF
Equipé des cartes modem 1200/2400 b et modem DSP 9600b packet
En parfait état de marche, programme sous Windows et avec documentation complète et schémas
Manual link:
http://www.sa6tlu.se/pmwiki/uploads/Utrustning/scs_ptc_II_manual_v4.pdf
Karta
Napomena: Prikazana je približna lokacija
- Oglas objavljen
- 13.12.2024. u 18:11
- Do isteka još
- oglas istekao
- Oglas prikazan
- 1364 puta