Holo Audio Spring 3 KTE DAC

Holo Audio Spring 3 KTE DAC u stanju novog.
Dac je pod garancijom do 28.1.2027. kod MagnaHiFi. Novi vlasnik se samo treba njima javiti za prijenos jamstva.
Dolazi sa originalnom dvostrukom kutijom, uputstvima…sve što dobijete sa novim.
Nisam za zamjene.

Key Features
A new generation of linear compensation technology. A better solution to the resistance, accuracy errors caused by switching components and PCB, after compensations makes the equivalent accuracy reach 0.00005%.
The new generation of de-glitch technology can provide a full range without increasing the noise floor or other adverse effects.
Based on this new generation of technology, “泉3” Spring3 (non preamp model) can provide a SINAD of >112dB and a dynamic range of >128dB, which represents the performance limit reached by today’s most advanced R2R architecture DAC.
Using the ultimate performance of PLL+FIFO technology, provides 0.1Hz Third-Order low-pass ability to inhibit jitter. It also uses a high-performance femtosecond VCXO as the PLL clock source. Under the premise of being almost immune to the front-end jitter, it can also lock up to 1.5us-2us @ 1KHz signal with high jitter. (It can lock up to 1.5us-2us @ 1kHz signal with high jitter on the premise of almost being immune front-end jitter).
The USB interface uses proprietary firmware with ultra-low latency, a highly reliable data transmission, ideal USB eye pattern measurements that contributes to 2-4 times higher performance than official firmware.
A single, independent HDMI-I2S input interface is provided, which has a four-way independent circuit, as opposed to standard LVDS chip, making I2S clock signals subject to lower interference and lower jitter. In addition, the I2S input can be configured with a specific pinout configuration, making it compatible with most of the HDMI-I2S digital devices on the market.

The following are added to the KTE (Kitsune Edition) of Spring 3:
100VA O-type (NOT toroid) Flat wire type as found in the flagship May DAC L2 and KTE.
All copper wire is replaced with 1.5mm pure OCC silver wire.
Hand-selected DAC module to have the best measurements compared to averages.
KTE Spring3 is the ONLY level to have the enhanced USB module as found in our L2 and KTE May DAC, featuring the Titanis 2.0 circuit.
Replaced IEC inlet connectors with pure silver/rhodium plated faston connectors at the IEC inlet.
HoloAudio Red Nano Fuse.
Holo Audio Caps (extensively tested to provide the very best sound quality).
Special Kitsune Tuned Edition branding inside and out (pure copper Kitsune fox emblem on top panel, similar to our extremely popular KTE SU2 product).