sE electronics sE7 matched pair - kondenzatorski mikrofoni upareni

sE electronics sE7 matched pair - kondenzatorski mikrofoni upareni

MPC: 270,00€, cijena za gotovinu/virman: 200,00€


sE7 is a high-quality back-electret small diaphragm condenser microphone intended for a wide range of studio and live sound applications, from acoustic guitars to pianos to drums and beyond.
The discrete electronics and the switchable attenuation pad ensure a high dynamic range, with high sound pressure level (SPL) handling capability and extremely low-noise components. The switchable low-cut filter helps eliminate rumble or footfall noise, and can also compensate for an excess of bass frequencies caused by the proximity effect. This enables the sE7 to close-mic many instruments including electric guitar speaker cabinets, brass instruments and drums.
The switchable -20dB attenuation pad prevents overloading your preamp or mixer and provides extended dynamic range, enabling close-mic techniques for even the loudest sources like brass instruments and snare drums.


Specifications:

Capsule Type: 1/2" back-electret condenser capsule
Polar Pattern: Cardioid
Frequency range: 20 Hz - 20 kHz
Sensitivity: 19 mV/Pa (-34.5 dBV)
Max SPL: 136 / 156 dBSPL (0/20 dB Attenuation pad)
Equivalent noise level: 16 dB(A)
Dynamic range: 120 / 140 dB (0/20 dB Attenuation pad)
Signal to Noise Ratio: 78 dB
Low-cut filter: 80 Hz, 6 dB/Oct, switchable
Attenuation Pad: 20 dB, switchable
Powering: 48 Volts according to IEC 61938
Electrical Impedance: less than 200 Ohms
Recommended load impedance: >1k Ohms
Current consumption: 3.0 mA
Connectivity: 3-pin male XLR connector
Dimensions: Diameter: 23 mm, length 120 mm
Weight: 128 g





www.promin.hr

POSJETITE NAS U I NOVOOTVORENOJ PRODAVAONICI U ULICI KRALJA TOMISLAVA 11, ZAGREB

Radno vrijeme: od ponedjeljka do petka 09-17 sati